What colors are prevailing - tonal or local, warm or cold?
Composition Wallboard. Composition wallboard usually presents no particular painting difficulties if the ordinary precautions are observed, such as making certain that the surface is dry and free from grease and oil. The painting procedure for wallboard is the same as for plaster; it requires a priming and sealing coat followed by whatever finishes coats are desired, or may be given one-coat flat or resin-emulsion type paint.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint.
What emotions does it produce?
Malabar and Designers Guild offer some striking brights while the new Shades of Sanderson comprises 120 colours tailored to Sanderson's collections. If you are aiming for a more subtle backdrop that will flow through several rooms, it's wise to stick to neutral shades. Kevin McCloud's Elements of Colour for Fired Earth works especially well with our cool, northern light.
The area covered by a gallon of whitewash depends upon the nature of the surface, but ordinarily a gallon will cover about 225 sq. ft. on wood, about 180 sq. ft. on brick, and about 270 sq. ft. on plaster. The formulas mentioned will make from 10 to 14 gallons of whitewash. If a smaller quantity is desired, the amount of each ingredient should be reduced proportionately.
Interior paints are used to obtain pleasing decorative effects, improve sanitary conditions, and insure better lighting. These paints may be divided into four types: wall primers; one-coat flats; flat, semigloss, and gloss; and water paints.