Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. If you want to balance color all around your current design, you need to have a comprehensive grasp on your existing color scheme. Next, determine the number of accessories required to make balance. Assume that your bedroom is using a split complementary color scheme. Olive green walls are a key part of this color scheme. You have located the primary complementary tone. As you ponder the components of your room, you will notice that the rust-red carpet offers a complementary color. The rug is a couple of shades darker than the shams and bedspread. Balancing a color palette with mauve can be done by using the color in throw pillows. Add unique wall plaques on the wall that include mauve elements along with the other colors. A mauve matte is an appropriate complement for a collection of watercolors. Selecting mauve in the lamp shades gives a great way to incorporate them into this bedroom. You can use a solitary element in your room's design to connect all of your items to each other like a window treatment. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it.
Traditional Paints. Available from specialists such as Farrow & Ball and The Real Paint & Varnish Company, lime wash and distemper paints can be useful for restoration projects, although some of the contents are potentially hazardous and can irritate eyes and skin. Use the modern equivalents where possible, as these are usually safer and more effective. Now is the time to paint the exterior of your home. It is best to start painting on the sunny side of your home first and the reason for that is because it's likely there is still dew on the shaded side of your home in the morning. Tip: Your house must be perfectly dry in order to start painting. Will this hair color make me look younger? Yes, a new hair color can make us look years younger, if the correct one is chosen. Gray hair is basically loss of color pigment in the hair follicle all together. It can make us looked washed out and much older. When we have our gray hair colored it brings depth and color to our skin also. This is accomplished by the hair color reflecting on to our skin tone, eyes, lips and so on. Having the hair colored appropriately with somewhat of a warm color, and then adding highlights, will take years off of our looks. This is because we have enhanced our looks with depth and then brought a bit of light back into the hair in contrast to the depth. It will be up to you and your hair stylist to choose the best color for you and your hair. Vinyl is a cousin to the tough plastic used for upholstery and floor tiles, but it comes thinned with water ready for you to brush, roll or spray on. The label on the can may say vinyl, vinyl emulsion, polyvinyl acetate or PVA.