Primer paints may be oil- or water-based and are used to seal unpainted surfaces to prevent covering coats of paint soaking in. The appropriate type of primer should be used for the surface being painted - wood, metal, plaster or tiles. There are some 'all purpose primers' available which are designed for two or more of these surfaces. Flat or Dead-Flat Oil - Provides a completely flat, oil-based finish. Generally used on walls but not suitable for areas of high wear. Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it.
Akbar (1556-1605) was the one who started encouraging of Mughal artist. After he had consolidated his political power, he built a new capital at Fatehpur Sikri where he collected artists from India and Persia. More than a hundred painters were employed, most of whom were Hindus from Gujarat, Gwalior and Kashmir. They worked under the two Persian master-artists Abdus Samad and Mir Sayyid Ali, but they were encouraged and inspired by Akbar. We are living in a highly pressurised and competitive world. There are more people chasing fewer jobs and in order to compete and survive in this world our children need to be as highly educated as possible. This has led parents to pressurise play-schools and nursery schools to begin teaching children reading, writing and arithmetic in the hope that they will be better prepared for formal schooling when they enter grade 1. Now that you have primed the airless, make sure that there isn't a tip in the gun of the airless and bring it over to the empty bucket. Since there is typically cleaning solution in the hose leading to the gun it is a good idea to spray that out until you see thick paint coming out. Once you have thick paint coming out you may put your tip back in. Remember that the tip will have an arrow on one side of the handle that shows which direction it must be in, in order to spray. PAINT. There are many types of paint available today, some giving different surface finishes, others are designed for a particular application. Choosing the correct paint type may appear to be confusing at first, but once you have projected which theme you would like to paint your house and sorted out which job and what finishes you want, the choice is rather easy.