Hope this helps you in deciding complete exterior paint job, or partial trim only exterior paint job, saving painting costs when you can, from your local area painting contractor.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
It's funny, but many of the colors that a paint company puts in its line would never look good painted on any wall. The colors are 100% used to grab your attention when you are perusing paint displays. People are helplessly attracted to bright colors; they are much more eye-catching and far more interesting to our brains.
Some manufacturers recommend their vinyl paints for interior as well as exterior use; others say no, not so good. There are vinyls made specifically for interiors.
You can tell when the bucket of paint is getting low when the airless starts pumping really loud and doesn't stop. Simply tip the nearly empty bucket of paint, at an angle so that the mesh filter is covered and wait for the airless to catch up and stop pumping. Sometimes it's just easier to just to replace the bucket of paint with the new one and when that starts going down, pour the excess from the old bucket into the new one.
If you have a timber floor that's not particularly attractive or is made from a patchwork of old and new wood, paint makes the perfect disguise. There are plenty of choices - all the colours from Farrow & Ball are available as floor paint and Nordic Style offers an elegant selection, too.
On the other hand, in some cases there are legitimate reasons for one area to be bad even if the rest of the paint is solid. If poor body work or rust repair was done in the past then maybe just that section of paint will need to be removed.