Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it.
A good interior paint job is often 50% preparation and 50% painting. Do not rush in preparing the surfaces in your eagerness to get at the brush or roller. If you do not prepare the surfaces properly, you'll be back with the paint brush or roller in a few months.
Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat.
THE BRUSHWORK. Depending on the art movement and personal peculiarities of the artist, the brushwork can range from delicate and almost invisible to rough and plastic.
Limewash - Made from slaked lime and water, this paint is good for porous surfaces such as brickwork, render and plaster and gives a chalky finish. It is available from specialist companies.
Today, it is increasingly easy to source ecologically sound paints, as most specialist ranges, such as Ecos, Earthborn, Georgina Barrow and Auro are available via mail order. There is a wealth of colour options in these pre-mixed ranges that include lush shades and muted palettes, reflecting their natural ingredients. Ecos continues to lead the field. It has recently developed Atmosphere Purifying Paint, which absorbs and neutralises volatile chemicals, solvents and VOCs from the atmosphere in a home.
Colors that are equally removed from a reference color are triadic colors. Since these color schemes can become too intense, unless they are very toned down, they are very problematic to manage. This color combination works well in a child's room, and it can be used effectively in a kitchen.