Inside the house is where acrylic shines. It dries faster than other types, and it keeps its color better, without yellowing. One disadvantage: It costs more.
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.
Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present.
After the siding of your home is painted you can now start on painting the trim. There are a couple different ways you can go about painting the trim of your house. The first way is to mask off all of the trim so that you can merely spray the trim color on to your house, and the second way is to roll the trim by hand. If you are the only person painting the house I would recommend rolling the trim by hand. The reason being is because it takes a long time to mask off all of the trim on your home compared to just rolling the face of the trim boards. If you have multiple people, it would be faster to have the helpers mask everything off while you start spraying the trim color.
Types of Paint. Water-based paints are usually referred to as emulsions and were traditionally used only for interior walls and ceilings. But recently tremendous advances in paint technology mean that water-based formulas, especially the high-performing acrylics, are available for all surfaces, from woodwork to metal, and for interior and exterior use. The advantages of these paints over oil-based ones is that they are cleaner, have less odour and are more environmentally sound. Brushes can be rinsed clean with water.
The casein, which serves as the glue binder, should be soaked in 2 gallons of hot water until thoroughly softened, which should be approximately 2 hours. After dissolving the trisodium phosphate in 1 gallon of water it should be added to the casein, stirring the mixture until the casein dissolves. This solution should be mixed with the lime paste and 3 gallons of water.
Now take a look at the form of the canvas - you might take it for granted, but it does influence the subconscious feeling you get when enjoying a piece of art. Round and oval canvases produce the impression of serenity and completeness, they are often picked for feminine, soft portraits, like Ingre's "Turkish bath". Rectangular paintings - vertical or horizontal - are more complicated. While widely used in landscapes, the horizontal format may serve to diminish the figure portrayed, impose or convey some limits, as you can see in Vrubel's "Demon". Vertical format ensures monumentality and steadiness.