Masonry Walls and Ceilings. Interior masonry walls and ceilings above grade may, in general, be painted in much the same manner as plaster surfaces. Here again, it is necessary to allow adequate time for the masonry to dry before applying paint and, in addition, attention should be given to the preparation of the surface. When decorating a wall containing Portland cement (concrete, for example), it is essential to take precautions against the attack of alkali. For this purpose, alkali-resistant primers such as rubber-base paints may be used when oil paints are to follow. When it comes to rolling out the walls never ever use a cheap foam roller. Foam rollers never evenly absorb the paint out of the pan and will actually add time to you project and cause more mess. Buy yourself a synthetic professional 3/8 nap roller head for about $6 to $8. Not only will the paint be applied in a smoother fashion you will experience less work and mess. Is the light neutral, sharp, mystical?
Water-thinned interior paints are calcimine, casein, resin-emulsion, and gloss water paints. Calcimine consists of powdered whiting and clay mixed with an animal-glue binder and a preservative. It cannot be recoated, but can be easily washed off before redecorating. "Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency. If you are going to paint your home and have decided to do it yourself take a little extra time and spend a bit more money to do it right. Colors are subjective, but the quality of materials and painting tools are not. For this example we are going to go through the process of painting the interior of a typical home. In just about every paint job I did I insisted that customers used an oil based paint on woodwork and doors. Not only does oil paint make wood look and feel better it gives you a superior durable and washable finish that water based latex paint can't. There is nothing worse than seeing a newly painted door or frame ruined by fingerprints and other marks. Use Plain White Primer for Light Paint Colors. In our first case, if you decide to paint a wall in your house with a light yellow color, but the wall is currently a deep dark brown, you will go through bucket after bucket of paint trying to cover that brown, easily doing 4 - 6 coats or more. But if you put down a coat of white primer first, you could be done after 2 coats of paint.