Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. A miniature painting, as the name signifies, is an intricate, colorful illuminations or painting, small in size, executed meticulously with delicate brushwork. The colors used in miniatures are generally derived from natural sources and materials. Some of the paintings use pure gold and other precious gems and stones to extract the colors for beautifying these miniature paintings. India has a long and varied tradition of miniature paintings. You can use vinyl on almost any exterior except previously painted wood. It works fine on wood shingles and shakes, asbestos shingles, brick, stucco, concrete and masonry blocks. One manufacturer says you can even put it on wood clapboard if the clapboard is new and unprimed.
Valspar Paint, for instance, also produces paint branded as Laura Ashley, Eddie Bauer, Waverly, and more. These separate lines, or collections, have their own color wheel displays and are usually available wherever the primary brand, Valspar in this case, are sold. Other examples are Disney Paints, currently produced by Behr, and Ralph Lauren and Martha Stewart, formerly produced by Sherwin Williams. Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint. The reality is that the guys shooting paint, even at the cheapest shops, know how to do it. They spray a dozen cars a week and have plenty of practice laying down smooth, consistent coats of paint. They work quickly and efficiently because they have to or they don't make money. They don't really make their money on shooting paint. They profit from body work because it takes time and insurance work because it pays well. Lets say you were using a 4" Fine China Bristle Paint Brush in some Alkyd Enamel Paint. And lets say the paint did not cover in 1-2 coats being such a dark tint that many do not cover in one coat. What do you do? A good disposable container may be close by in the newly formed 2lb-7oz. Maxwell House Coffee Blue Plastic Container with snap on lid. Cut a small X in the center of lid, filling container up 2-3" of Painters Mineral Spirits or Lacquer Thinner. Placing Paint Brush in container, running handle through lid's X, snapping it shut when not in use, and after each paint application. This will keep Brush moist and ready for next use, with no cleanup in between, only having to blot it dry on a clean rag next time. Maxwell House Container also makes a perfect cut-in bucket having an easy built-in handle right onto container, for ease of handling, and caring for one's Brush.