Now let's proceed to analyzing the center of the composition. There is an optical center in the middle - you will notice that the center of the composition, the major element will never be placed there, otherwise the scene will look artificial. The center of the composition will always be the most striking element, and the rest will just serve to make it more expressive. The artist may use various means to achieve this effect - the color contrasts, light and shade effects, size of objects and distance between them. Secondary elements are depicted with less detail and vigor - they have to bring forward the center, not block it. Notice the way your eyes travel the painting - intuitively you will start at the center and will proceed to the rest of the elements to refine the story. Fortunately, you can always get your primer tinted for free. Getting your primer colored the same as your paint will save you a coat of paint. Of course, I always recommend doing a minimum of 2 coats of paint so that your finish sheen looks consistent. Cheaper then doing it yourself. Some would argue that if you're going to all the trouble to fully prep the car yourself, then why not just shoot the paint as well? Why get a shop involved? The answer is simply that you'll get a better job and for less money. Some would argue with this, but the fact is that if you've never sprayed a car before then your first car will have a steep, and expensive learning curve. Laying down an even, consistent coat of paint takes considerable practice. Also, paint and equipment is not cheap. You'll need to buy primer, color coat, clear coat, reducers & catalysts. None of these are inexpensive and you can easily spend as much in paint materials alone as the cheapest paint job at Maaco or similar shop.
You can use vinyl on almost any exterior except previously painted wood. It works fine on wood shingles and shakes, asbestos shingles, brick, stucco, concrete and masonry blocks. One manufacturer says you can even put it on wood clapboard if the clapboard is new and unprimed. Knock down texture is basically a orange peel that is sprayed on and allowed to "set-up" for a minute or two then gently "knocked down" by running a 6" drywall knife over it, "knocking down" the surface of the texture. Although knock down is a flattened version of orange peel, I suggest you do not use a spray can of orange peel, the knock down comes in its own spray can and the results are much better, again experiment before spraying it on the wall. However, If ever you apply any of the textures to the wall and are not satisfied with the results, wash the texture off immediately before it dries, then allow the wall to dry and try it again. Once you have the texture applied to your liking and you have allowed it to dry, you may want to paint the patches a couple of time before painting the entire wall, especially for walls where the paint to be applied will have some sheen. Multiple coats on these areas will make them blend in, unnoticeable, with the rest of the wall. You will know if the patches need more coats of paint, because the patch/texture will have absorbed the paint causing the spot to look duller than the rest of the existing wall. Five categories are used to describe VOC content. For guidance, a minimal VOC content is up to 0.29 per cent, whereas a very high VOC content is above 50 per cent. All brands have, where necessary, reformulated their ranges to give minimal VOC content. A large whitewash brush is best for applying the wash. One should not attempt to brush out the coating, as in applying oil paint, but simply spread the whitewash on as evenly and quickly as possible.