Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. The most challenging question and statement a stylist or colorist can receive is: Can you correct this hair color I applied at home? It looks terrible! I personally love doing corrective hair coloring. A lot of hair stylist do not like this area of our field. Be sure your stylist has plenty of experience in this area of hair coloring if you need this service rendered. I really won't go too in depth here about corrective hair coloring, accept that, usually a botched at home color can be corrected with the following: Time at the salon for the correction. Money, as this service can be expensive. Cooperation with, and trust in, the hair stylist's or hair colorist's judgment. Airless Tip: If you have somebody who can start masking off the trim, have them start on that while you convert the airless to a new color. When changing colors with an airless paint sprayer it is a good idea to have a second bucket filled half way with clean water. Place the intake hose in the clean water gently without getting the old color everywhere in the water. Take the tip out of the airless and spray all of the old paint out of the hose and back into its original paint bucket. Be careful when doing this that you recognize when the paint starts turning watery. When it does point the gun into the first bucket and spray until it looks pretty clean. It doesn't need to be perfectly clean. When it looks good, clean off the intake line in the clean bucket and get the old color off the intake line. Now place the intake line inside of your new trim paint.
Even if you don't need to apply a coat of primer before your new coats of paint, doing so will always save you money. Whether you use white or tinted primer, a coat of primer is always more cost effective for one simple reason: It is cheaper! In fact, primer may cost as little as half as much as standard paint. If you get it tinted the same as your paint, then it is cheaper by the coat. If you use white, as in the first scenario above, it will also minimize the number of coats of paint you have to apply. Either way it reduces how much paint you have to buy. Do you want to learn more about maximizing your paint color coverage, minimizing your paint usage, optimizing coats, and perfecting your primer? Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk. If a desired shade is not obtainable in custom-or ready-mixed paints, white paints may be tinted with colors-in-oil. To do this, mix the color-in-oil with a small amount of turpentine or mineral spirits and stir this into the white paint, a little at a time. If a blended color is desired, more than one color may be added, such as a chrome green and chrome yellow pigments to produce a lettuce green shade. Satin paints offer a good combination of easy-clean and moderate sheen. These paints go a step above eggshell in scrubbing ability. They perform and look great in just about any room.