Coloring pages reindeer

Published at Thursday, 5 March 2020.

STENCILING. You may want designs on the walls, or perhaps even on floors and ceilings, in some of the rooms or hallway. You may buy or make your own stencils, which should be on heavy paper, stencil board, plastic, or metal. Avoid stencils made of lightweight paper which will get soaked when touched by wet paint. Your paint dealer will suggest the best paint for you to use, as it will depend a great deal on the surface over which you want to put the stenciled designs. Generally a heavy paint is used, so that it will not spread under the stencil while you are applying it. Semi-gloss paints are very similar to gloss plaints except it has lesser sheen. Semi-gloss is also suitable for rooms with high humidity (best used for children's room) and can be used for trim works and casings. These paints ensure maximum durability. Plaster. New dry plaster in good condition, which is to be finished with a paint other than water paint, should be given a coat of primer-sealer and allowed to dry thoroughly before being inspected for uniformity of appearance. Variations in gloss and color differences in the case of tinted primers indicate whether or not the whole surface has been completely sealed. If not, a second coat of primer-sealer should be applied. If only a few "suction spots" are apparent, a second coat over these areas may be sufficient.

Are the contours rough or concealed? So how does a paint company accomplish this color hypnosis of potential customers? Well, it starts with the sample card. Have you ever noticed how the brightest, most saturated color sample cards are always the first row you see in a paint display? Well you guessed it... paint companies are playing with a loaded deck (of sample cards, that is)! Gloss - These paints have a high sheen level and are usually used on woodwork. Our next step is mixing the oil paint. DO NOT SKIP THIS STEP. Obviously you will need to buy some paint thinner, but the most important product you will need is Penetrol $12. Take a plastic quart cup that you will be painting out of and fill it up about three quarters with paint. Now mix in a couple of tablespoons of Penetrol and the slightest amount of thinner. Mix it up with a stick real good and you are ready to go. Why Penetrol? This product is the key to a fantastic looking job. Penetrol will not only smooth out the finish it will extend the time (usually about 20 minutes) before the paint starts to get sticky. This will allow you to apply a glass like finish and eliminate brush marks. We are going to apply two coats here as well so don't glob on the paint. When you are painting the door frames get used to the paint and watch your drips. After about ten minutes or so you will get used to how the paint flows and how damn good your finish looks. Allow to dry overnight before apply second coat. Tip: after you apply the second coat remove the tape and don't allow to dry first. You will get a little paint on your hands from the tape, but deal with it. By removing the tape now you will ensure crisp lines. In some case when you allow the second coat to dry you will pull a bit of the oil paint off. It is not common, but in my opinion why take the chance.

Leave a Reply