The paints may be applied by brush or spray; the small spray attachment for vacuum cleaners is very convenient, especially for painting radiators. The term paint is used to include paints, varnishes, enamels, shellacs, lacquers, and stains. • Paints are composed of mineral pigments, organic vehicles, and a variety of thinners all combined. • Varnishes are resins dissolved in organic thinners. • Enamels are pigmented varnishes. • Shellac is lac gum dissolved in alcohol. • Lacquers may be both pigmented or clear - the liquid portion usually is treated nitrocellulose dissolve in thinners. • Stains may be pigmented oil or a penetrating type. Many of these materials, such as paints, varnishes, and lacquers, are formulated for specific purposes: • Outside house paints and exterior varnishes are intended to give good service when exposed to weathering • Interior wall paints are formulated to give excellent coverage and good wash-ability. • Floor enamels are made to withstand abrasion. • Lacquers are formulated for rapid drying. • There are also formulas which provide extra self-cleaning, fume- resisting, waterproofing, hardening, flexibility, mildew-resisting, resistance to fading, and breathing qualities. STIPPLING. Whether you desire the effect of stippling (tiny paint dots) as a decorative effect, or if you have a wall which has an uneven surface and you feel you can hide the defect by stippling it, you may accomplish this result very simply.
Proper brush technique: When "cutting in" with a paint brush you should dip the brush in paint and tap the sides of the bucket on each side of the brush, leaving a good amount on the brush so you are able to minimize the times you will need to dip/load the brush. Next, take the brush and make a one foot to two foot line down the wall about an inch or two away from the trim or surface you are going to paint up next to, this is much like taking a knife full of butter and spreading it across an entire slice of bread. After, spreading the paint over the section, go back and even the paint out evenly across the section and cut up next to the trim with the brush. You want to paint up next to the trim or surfaced to be cut-in with the paint brush after you have released most of the paint on the wall, it is easier to cut in with the tips of the brush exposed and not loaded with a lot of paint. CONCLUSION. Once again go through the images and the story of the painting. Was your first impression different from what you see now? Take a 5-minute online test to explore your preferences in fine arts. In 5 minutes you will confidently say "I prefer impressionist cityscapes", or "This room calls for a color field painting", "I need to have an art nouveau nude in my bedroom" - and you will know what you are talking about! * To design a look with analogous colors, you can have any three colors next to each other on the color wheel. Successfully combining these colors in a room is one of the easiest, next to using monochromatic colors. In general you will want your design to use similar tones throughout the room except in the case of accent colors, which may be bolder. Do all your own body work . As mentioned earlier, the key to keeping your paint shop costs down is to do as much as possible before you take it to the shop. This includes body work, if you've got the skill, or the patience to learn the skill. Bodywork is time consuming. It requires several steps that must be done in the correct order, with the correct curing times in between. Shortcuts here will show up like a sore thumb in your new paint job, so don't be tempted. If you don't have the skill to tackle the body work yourself then it's smarter to let the paint shop do it. Just understand that this raises the cost of your paint job significantly. Good body work takes hours upon hours and having a professional do it can easily exceed the cost of a cheap paint job.