Paint should not be applied to a concrete basement floor until the concrete has aged for at least a year. The floor should be dry when painted, the best time for application being during the winter or early spring (assuming there is some heating apparatus in the basement), when the humidity in the basement is low. In general, three coats of paint are required on an unpainted floor, and the first coat should be thin to secure good penetration. After the paint is dry, it should be protected with a coat of floor wax. Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it. Step three: go online and study the basics of shadow and light. It's a visual thing, and too complicated to talk about here. But once you see it, it'll come to you quickly. Simply Google "shadow and light in painting" and the basics will come up. Once you know these rules, you can apply it to any shape, any form, any painting. And it'll make you keenly aware of shadow and light on virtually any object on earth. It's what makes a painting three- dimensional and expensive looking. You can also buy art books on shadow and light at any bookstore. But make sure you sit down for a couple of hours and study it. It will come quickly to you, I promise.
SECONDARY COLORS. When you mix two primary colors together, you get a secondary color. The secondary colors are orange, green and violet. Orange is made by mixing red with yellow. Green is made by mixing blue and yellow. Violet is made my mixing blue with red. When you plan with split complementary colors, you begin with a single reference color. Next, choose a color from either edge of the complementary color and use it. While the complementary color scheme is a little more obvious, this scheme can fail totally if you just use paler versions of your warm colors. By the same token, picking a a warm undertone for the main contrasting color and combining it with two cool tones will showcase the warm tone. Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk. Mixing. Paste paints, such as aluminum, resin-emulsion, and lead-in-oil, should be stirred with a stiff paddle and reduced to painting consistency with the liquids recommended on the manufacturer's labels.