Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. Preparation, the key to a successful paint job is to take the correct steps when preparing the job. Preparation for this article, has two parts, the first part is wall prep. The walls you are going to paint may have nail holes or imperfections that need to be filled before you paint. The proper way to fill them, if they are smaller is with water putty, by simply forcing a little bit of the putty in the hole and breaking it off flush with the surface. For larger depressions, use a drywall compound or spackle, which may require a second application to fully fill the indentation and make the repair/"patch" flush with the wall. Rajput paintings depict a number of themes, events of epics like the Ramayana and the Mahabharata, Krishna's life, beautiful landscapes, and humans. Miniatures were the preferred medium of Rajput painting, but several manuscripts also contain Rajput paintings, and paintings were even done on the walls of palaces, inner chambers of the forts, havelies, particularly, the havelis of Shekhawat.The colors extracted from certain minerals, plant sources, conch shells, and were even derived by processing precious stones, gold and silver were used. The preparation of desired colors was a lengthy process, sometimes taking weeks. Brushes used were very fine.
Cold water paints of the casein type may be applied either directly to a plastered surface, or the surface may be first given a coat of primer-sealer to equalize uneven suction effects. The same is true of resin-emulsion paints, with the recommendations of the manufacturer of the product being given preference in case of doubt. Since resin-emulsion paints usually contain some oil in the binder, they should ordinarily be applied only to plaster which has dried thoroughly. Definitely good inside the house is a new vinyl primer-sealer to be used as a base coat under any paint. It dries in as little as 30 minutes. Mewar School of Painting: These represent hunting scenes which are painted on cloth and handmade paper using stone colors Fine motor: Beginning to learn to use a pencil before you have developed finger and thumb strength and stability results in a child developing an inefficient pencil grip. When a child has weak thumb stabilisers, he is likely to wrap his thumb around his index finger to try to create greater stability. This makes it very difficult for him to then develop the necessary finger isolation (separate movement of the fingers to give easy, dextrous pencil control). Children who have not yet developed their wrist stability will try to use whole-arm movements to do their drawings and writing and will press very hard. If a child has not developed the bilateral integration (this happens in the brain and is the smooth, efficient communication of the right side of the brain with the left) cutting will be difficult and he will have difficulty writing across his page and reading across a page or school board. Beginning to use a pencil too soon therefore inhibits learning in a formal class setting, rather than helping it.