Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. If you decide to do your own body work discuss it with the paint shop first. They'll probably have recommendations on the type of primer you use. Some brands will be more compatible with their primers or color coats. The rule of thumb is to stay within the same brand of paint, both for prep and color. Even the cheapest paint shops typically use a brand name on their intermediate and higher paint jobs. Find out what it is and use the same brand as your primer coat. This will ensure you don't create adhesion problems for yourself down the road. Rajput paintings depict a number of themes, events of epics like the Ramayana and the Mahabharata, Krishna's life, beautiful landscapes, and humans. Miniatures were the preferred medium of Rajput painting, but several manuscripts also contain Rajput paintings, and paintings were even done on the walls of palaces, inner chambers of the forts, havelies, particularly, the havelis of Shekhawat.The colors extracted from certain minerals, plant sources, conch shells, and were even derived by processing precious stones, gold and silver were used. The preparation of desired colors was a lengthy process, sometimes taking weeks. Brushes used were very fine.
The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Mewar School of Painting: These represent hunting scenes which are painted on cloth and handmade paper using stone colors When you are including the finishing touches on a area with accessories, make sure that you remember this one important thing.. It is important to know which color is dominant. Do you desire for things to stay that way? Now highlight the main color with your accessories. Using accessories like paintings, throw pillows and baskets in bolder colors can help detract attention from other parts of the room. "Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.