Disability awareness coloring pages

Published at Saturday, 9 May 2020.

Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. If you have a vinyl top then remove the molding separating the vinyl and paint. Drip rail chrome really should be removed also, but can be extremely hard to take off undamaged. If you plan on buying all new drip molding then definitely remove the old for painting. But if you want to keep the originals then it might be better to leave them on and let the painter mask around. If you have hub caps it's easy to just take them off. While the paint shop should completely mask all four tires, overspray can still find its way in. It's sometimes better to play it safe and just remove wheel covers. You will need any of these tools in painting your exterior: caulk, sandpaper, rags and/or paper towels, painter's tape, garden hose, power washer, or hose brush attachment, sponges & buckets for wash water, spray nozzle, stepladder, extension ladder, paint scraper, wire brush, putty knives, heat gun, rotary paint removing tool and electric drill, caulk gun, sanding block, and work gloves.

Remove side view mirrors (unless they're to be body color) as well as exterior door handles and locks. This will take some extra time because you need to remove the interior door panels to get these off, but it's worth it. Head lights, tail lights, marker lights and license plates should come off too, but you'll need them in place to drive to the paint shop. So bring some tools so you can quickly take these off once you arrive. Depending on the year Mustang you can just take off the chrome bezels or rings. The shop can then easily mask the headlight or tail light itself and still get plenty of paint around the edges. Store your leftover paint in plastic Rubbermaid beverage jugs or other plastic seal-able containers. Paint left in the can always gets funny after time. Either the can isn't properly sealed of it gets exposed to extreme heat or cold. I like to store my paint inside where the temperature is controlled. Solvent or oil-based paints are used where a tough, durable finish is required for interior and exterior timber, masonry and furniture - although, as mentioned above, the new generation of acrylics and multi-surface paints offers viable alternatives. In general, brushes need to be cleaned with turpentine or white spirit. Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M.

Leave a Reply