Primer paints may be oil- or water-based and are used to seal unpainted surfaces to prevent covering coats of paint soaking in. The appropriate type of primer should be used for the surface being painted - wood, metal, plaster or tiles. There are some 'all purpose primers' available which are designed for two or more of these surfaces. HUE-VALUE-INTENSITY. Hue: Without getting too technical, and to put things into laymen's terms, hue is just another word for color. For instance, grass and leaves are two variations of a green hue. Materials and their application, every paint manufacturers paint will vary. If you are freshening up old walls and painting back to the existing color, the product doesn't have to be high end or have good coverage. If you need to paint a dark color over light color or light color over dark, you may want to consider purchasing a top quality paint to avoid multiple coats. I suggest Valspar, Pittsburgh or Benjamin Moore top of the line wall paint. These brands work well for straight out of the bucket use and are application friendly. Sherwin Williams is not my first choice because the coverage is poor and you will have to apply multiple coats but, it does apply, fluently. If you find a product does not apply well, maybe it is to heavy and/or sagging on the wall, you may need to thin the paint with a little water, this will reduce the coverage but make the paint flow better and lay down nicer on the surface. I do recommend latex paints for all applications, these days a good high end latex is as good as oil paint and your tools clean up much easier, it will also be less harsh on the respiratory system. The only situation I recommend oil paint, is as a primer/stain blocker over stains that "bleed" through the paint. You can get a stain blocking oil primer in a convenient spray can and spot prime any trouble areas before painting and in the case you need to prime all of the wall due to smoke or water damage, I recommend getting it in gallons and rolling it on where the stains are present. Don't forget proper ventilation and/or a respirator when using the oil based primers!
Proper rolling technique: When rolling paint on the wall, get the roller skin evenly loaded with paint and make a V,N or M pattern on the wall, this is to spread the paint across the entire section you will be rolling, then roll back across the section and even out the paint. To properly "lay off" each section, make a final pass of the section applying light pressure to the roller frame arm end of the roller skin and bringing the nap mark (mark created on the pressure applied side of roller skin) across from the beginning of the section to the end of the section, and just repeat all the way down the wall.The V,N or M pattern, will be determine by how far the paint will spread, a V is for less spreading paint and M is for farther spreading paints. Do not "dry roll", which means trying to roll to much of a section at once with very little paint on the roller. Just as important, do not apply to much, if you find you are applying to much, increase the size of the section you are painting i.e. from a V pattern to an N or a N pattern to a M. Satin or silk - Water-based vinyl or acrylic paint for walls in high-wear areas, such as hallways and kitchens. A satin finish will be slightly shinier than silk. Satinwood or semi-gloss - These paints are commonly used on woodwork, such as skirting boards. This sheen level is between eggshell and gloss. And if you are changing colors be sure you and the paint shop are crystal clear on what color they're going to spray. Never just describe the color. You won't get what you want. Guaranteed. If you're not using a factory original color then find out what kind of car the color you want came on. Give the shop a year, model and paint name and then insist on seeing a paint chip. Take the chip outside to see it in the sun light and verify that it's what you want. There's nothing more disappointing then spending all these hours and money only to watch your car come out of the shop the wrong color.