Inside the house is where acrylic shines. It dries faster than other types, and it keeps its color better, without yellowing. One disadvantage: It costs more.
One precaution: You can't paint with it in cold weather. The chemical reaction that transforms the water solution into a durable finish will not take place if the temperature is below 50°. (Conventional oil paints don't stick well in cold weather, either.)
You'll need a large compressor, not just the typical 20 gallon variety most of us have. This is a 60 gallon, vertical compressor with typically a 5+ hp motor. Then you'll need a decent paint gun (possibly 2; one for primer and one for color) which again is an expense. Then there's the question of where you'll paint the car. Renting a paint booth is best, but can be expensive and hard to find. You can always seal up your garage or shoot out in the wetted down driveway, but you'll inevitably get dirt and moisture into the paint.
Akbar (1556-1605) was the one who started encouraging of Mughal artist. After he had consolidated his political power, he built a new capital at Fatehpur Sikri where he collected artists from India and Persia. More than a hundred painters were employed, most of whom were Hindus from Gujarat, Gwalior and Kashmir. They worked under the two Persian master-artists Abdus Samad and Mir Sayyid Ali, but they were encouraged and inspired by Akbar.
Better still, you don't have to spend hours getting ready and hours cleaning up afterward. Premixed paints, electric-drill attachments and self-dispensing calking guns make short work of preparation. Cleaning up is a soap-and-water job for the rubber paints, or a quick dip in special cleaners for the oils. Disposable dropcloths and paper paint pails are used once and thrown away.
Once you figure out which position is prime and which position is spray, place the valve in the prime position and grab the primer hose. Point the primer hose in the empty bucket near the top and at an aproxx.45 degree angle from the side (the reason for this is that there is likely to be pressure still built up in the airless and when you first switch on the airless to prime it, paint will likely burst out of the primer hose and you don't want to have it go everywhere). Now turn the airless paint sprayer on and you will see that the airless is sucking up the new paint and pumping out the primer hose. At first you will typically see a cleaning solution come out followed by your paint. When you see your paint coming out switch over the primer valve to the other position and you will see the airless pumping paint into the main hose.
If you have a timber floor that's not particularly attractive or is made from a patchwork of old and new wood, paint makes the perfect disguise. There are plenty of choices - all the colours from Farrow & Ball are available as floor paint and Nordic Style offers an elegant selection, too.