What colors are prevailing - tonal or local, warm or cold?
Plaster. New dry plaster in good condition, which is to be finished with a paint other than water paint, should be given a coat of primer-sealer and allowed to dry thoroughly before being inspected for uniformity of appearance. Variations in gloss and color differences in the case of tinted primers indicate whether or not the whole surface has been completely sealed. If not, a second coat of primer-sealer should be applied. If only a few "suction spots" are apparent, a second coat over these areas may be sufficient.
"Boxing" is a good method of mixing paints. Since paint is a mixture of solids and liquids, it is important that it be mixed thoroughly before using. To do this, the greater portion of the liquid contents of the can should be poured in a clean bucket somewhat larger than the paint can. Then, with a stiff paddle, the settled pigment in the original container should be loosened and any lumps broken up. After this, mix the material in the container thoroughly, using a figure 8 motion, and follow with a lifting and beating motion. Continue stirring the mixture vigorously while slowly adding the liquid that was previously poured off the top. Complete the mixing by pouring the paint back and forth from one container to the other several times until the entire amount is of uniform consistency.
Alkyd has solid advantages overriding the slight cleanup in-convenience. It is exceptionally tough and very resistant to scrubbing. It stands up well in the trouble spots - trim, bathroom, kitchen. And it is easy to apply, producing a smooth, even finish free of streaks and brush marks.
When you plan with split complementary colors, you begin with a single reference color. Next, choose a color from either edge of the complementary color and use it. While the complementary color scheme is a little more obvious, this scheme can fail totally if you just use paler versions of your warm colors. By the same token, picking a a warm undertone for the main contrasting color and combining it with two cool tones will showcase the warm tone.
For stippling you need a special brush; get one that is flat, and has short, stiff bristles.
If a desired shade is not obtainable in custom-or ready-mixed paints, white paints may be tinted with colors-in-oil. To do this, mix the color-in-oil with a small amount of turpentine or mineral spirits and stir this into the white paint, a little at a time. If a blended color is desired, more than one color may be added, such as a chrome green and chrome yellow pigments to produce a lettuce green shade.