Paint & Paper Library arranges its colours in five shades from light to dark to help select coordinating colours for ceilings, cornices, walls, doors and woodwork. If you are decorating around bold furnishings, such as a sofa or curtains, look at paint colours from the same fabric house as they are most likely to be sympathetic. Jodhpur School: The centre of this hand made paintings are love scenes then the other art figures. The Jodhpur School of Miniature paintings depict love scenes of lovers Dhola and Maru on camel back. There are hunting scenes with elephants and horses. The major colors used in this style of painting are gold and stone color. You scuff up existing paint for two reasons. First, you want to get rid of any oil, grease or dirt trapped in the top layer of paint. This is the stuff that cleaners and degreasers can't get off. The second reason to scuff is to set up a physical bond for the new primer and paint to adhere to. You want to give the old paint some tooth so the new sticks better.
Flat or Dead-Flat Oil - Provides a completely flat, oil-based finish. Generally used on walls but not suitable for areas of high wear. Note: How to use an airless paint sprayer. I'm sure the guy at the rental store showed you how to use the airless (typically with his limited experience of actually painting a house), so hopefully I can offer you a couple new ideas on how to paint your home using an airless paint sprayer. When you first get the airless home, set it in the middle of the area that you would like to start painting. Typically the length of the hose is around 50'. Stretch out the hose prior to painting so that you don't have to worry about unraveling it while you are painting on a ladder. It is a good idea to have a 100' extension cord so that you can bring the airless anywhere you wish to paint without any restrictions. Tip: before you plug in the airless into the extension cord, MAKE SURE THE AIRLESS IS OFF! You don't want the airless to start pumping without paint! Now, when you go to set up the airless, before you turn it on, it's a good rule of thumb to have a second empty bucket next to your bucket of paint. I'll explain why in a second. Place both buckets side by side and place the intake hose (with the wire mesh filter end) into your 5 gallon bucket of paint while the primer hose (usually a lot smaller, about the size of a pencil'ish) is placed in the empty bucket of paint. Before you turn on the machine make sure that the airless is set to prime the machine first. There is a primer valve that you can rotate between prime and paint. A good way to see if the valve is set to prime or paint is to try this little test prior to turning the machine on. While turning the valve clockwise a couple times you will notice that the valve handle will separate from the machine in one position (leaving a slight crack between the valve and machine) while the other position the valve is close to the machine. The position in which the valve is separated from the machine is considered the primer position. Do this multiple times to see what I'm talking about. Don't worry if you keep on spinning the valve, you can spin it a million times in one direction and it won't hurt it. The most challenging question and statement a stylist or colorist can receive is: Can you correct this hair color I applied at home? It looks terrible! I personally love doing corrective hair coloring. A lot of hair stylist do not like this area of our field. Be sure your stylist has plenty of experience in this area of hair coloring if you need this service rendered. I really won't go too in depth here about corrective hair coloring, accept that, usually a botched at home color can be corrected with the following: Time at the salon for the correction. Money, as this service can be expensive. Cooperation with, and trust in, the hair stylist's or hair colorist's judgment. Preparation, the key to a successful paint job is to take the correct steps when preparing the job. Preparation for this article, has two parts, the first part is wall prep. The walls you are going to paint may have nail holes or imperfections that need to be filled before you paint. The proper way to fill them, if they are smaller is with water putty, by simply forcing a little bit of the putty in the hole and breaking it off flush with the surface. For larger depressions, use a drywall compound or spackle, which may require a second application to fully fill the indentation and make the repair/"patch" flush with the wall.