Repainting your house is a tricky business. Some rely on painting companies to do the job for you. Hiring the house painting service may also cost you. But if you are planning to paint it yourself, you might want to consider the basics; and consider the time and effort you will put on painting your house. Now here comes the fun part doors and wood work. This is where most people opt to use latex which is a huge mistake. Your home is your biggest investment don't cut corners on it's aesthetics. You want the finish on your woodwork to stand out from the walls especially if you have crown moulding or waynes coating. Don't be fooled by water based products that claim to give the look and finish of oil. It's just good marketing preying on people's fears of painting with oil. Don't believe the hype as those samples they show you have 3 or 4 coats that have been professionally sprayed in a dust free environment. You will not get the same results I can promise you that. You have a choice of semi-gloss or gloss finish. I prefer gloss because to me it gives you a bit more durability and shine. Either one will be fine for your project. Now let's get started. STIPPLING. Whether you desire the effect of stippling (tiny paint dots) as a decorative effect, or if you have a wall which has an uneven surface and you feel you can hide the defect by stippling it, you may accomplish this result very simply.
A Gloss paint is easy to clean and resists scuffs better. This is ideal for rooms that are constantly used. Most gloss paints are best recommended to use on woodworks, baseboards, kitchen and bathroom walls, doorjambs, and window casings. The downside of using gloss paints, however, is the noticeable imperfections in the wall surface. Alkyd has solid advantages overriding the slight cleanup in-convenience. It is exceptionally tough and very resistant to scrubbing. It stands up well in the trouble spots - trim, bathroom, kitchen. And it is easy to apply, producing a smooth, even finish free of streaks and brush marks. Our next step is mixing the oil paint. DO NOT SKIP THIS STEP. Obviously you will need to buy some paint thinner, but the most important product you will need is Penetrol $12. Take a plastic quart cup that you will be painting out of and fill it up about three quarters with paint. Now mix in a couple of tablespoons of Penetrol and the slightest amount of thinner. Mix it up with a stick real good and you are ready to go. Why Penetrol? This product is the key to a fantastic looking job. Penetrol will not only smooth out the finish it will extend the time (usually about 20 minutes) before the paint starts to get sticky. This will allow you to apply a glass like finish and eliminate brush marks. We are going to apply two coats here as well so don't glob on the paint. When you are painting the door frames get used to the paint and watch your drips. After about ten minutes or so you will get used to how the paint flows and how damn good your finish looks. Allow to dry overnight before apply second coat. Tip: after you apply the second coat remove the tape and don't allow to dry first. You will get a little paint on your hands from the tape, but deal with it. By removing the tape now you will ensure crisp lines. In some case when you allow the second coat to dry you will pull a bit of the oil paint off. It is not common, but in my opinion why take the chance. The stencil must be held very firmly against the surface with one hand, and the stencil brush worked over it quickly with the other hand. Or, if you have an assistant, it is best for one person to keep the stencil steady, while the other does the painting. In removing the stencil, make sure you pick it up without smudging.