A good interior paint job is often 50% preparation and 50% painting. Do not rush in preparing the surfaces in your eagerness to get at the brush or roller. If you do not prepare the surfaces properly, you'll be back with the paint brush or roller in a few months. Matt - Describes paints that give a flat, non-reflective finish. It is ideal for walls and ceilings that are not perfectly smooth. If you decide to do your own body work discuss it with the paint shop first. They'll probably have recommendations on the type of primer you use. Some brands will be more compatible with their primers or color coats. The rule of thumb is to stay within the same brand of paint, both for prep and color. Even the cheapest paint shops typically use a brand name on their intermediate and higher paint jobs. Find out what it is and use the same brand as your primer coat. This will ensure you don't create adhesion problems for yourself down the road.
EXTERIOR PAINTING. In buying paints that you are going to use for your exterior house, you have to pick a brand that has essential characteristics: hiding power, color retention, chalk-resistance, and blister resistance. Our next step is mixing the oil paint. DO NOT SKIP THIS STEP. Obviously you will need to buy some paint thinner, but the most important product you will need is Penetrol $12. Take a plastic quart cup that you will be painting out of and fill it up about three quarters with paint. Now mix in a couple of tablespoons of Penetrol and the slightest amount of thinner. Mix it up with a stick real good and you are ready to go. Why Penetrol? This product is the key to a fantastic looking job. Penetrol will not only smooth out the finish it will extend the time (usually about 20 minutes) before the paint starts to get sticky. This will allow you to apply a glass like finish and eliminate brush marks. We are going to apply two coats here as well so don't glob on the paint. When you are painting the door frames get used to the paint and watch your drips. After about ten minutes or so you will get used to how the paint flows and how damn good your finish looks. Allow to dry overnight before apply second coat. Tip: after you apply the second coat remove the tape and don't allow to dry first. You will get a little paint on your hands from the tape, but deal with it. By removing the tape now you will ensure crisp lines. In some case when you allow the second coat to dry you will pull a bit of the oil paint off. It is not common, but in my opinion why take the chance. Special paints have been innovated from different consumer insights and brilliant paint technology that allows specific paints for specific needs. For localities where such conditions exist, self-cleaning paints should be selected. These paints are usually so designated on the label. Concrete, plaster, and metal surfaces each present special problems in painting. For instance, paint for use on masonry or new plaster must be resistant to dampness and alkalies, and paints used on steel must have rust-inhibitive properties.