Repainting your house is a tricky business. Some rely on painting companies to do the job for you. Hiring the house painting service may also cost you. But if you are planning to paint it yourself, you might want to consider the basics; and consider the time and effort you will put on painting your house.
Cheaper then doing it yourself. Some would argue that if you're going to all the trouble to fully prep the car yourself, then why not just shoot the paint as well? Why get a shop involved? The answer is simply that you'll get a better job and for less money. Some would argue with this, but the fact is that if you've never sprayed a car before then your first car will have a steep, and expensive learning curve. Laying down an even, consistent coat of paint takes considerable practice. Also, paint and equipment is not cheap. You'll need to buy primer, color coat, clear coat, reducers & catalysts. None of these are inexpensive and you can easily spend as much in paint materials alone as the cheapest paint job at Maaco or similar shop.
HUE-VALUE-INTENSITY. Hue: Without getting too technical, and to put things into laymen's terms, hue is just another word for color. For instance, grass and leaves are two variations of a green hue.
The area covered by a gallon of whitewash depends upon the nature of the surface, but ordinarily a gallon will cover about 225 sq. ft. on wood, about 180 sq. ft. on brick, and about 270 sq. ft. on plaster. The formulas mentioned will make from 10 to 14 gallons of whitewash. If a smaller quantity is desired, the amount of each ingredient should be reduced proportionately.
To balance, you must grasp the interconnectedness of color schemes. All these interactions are defined in the color wheel, and it has been used to build color schemes for centuries.
The principal ingredient in whitewash is lime paste. A satisfactory paste can be made with hydrated lime, but better results are obtained by using quicklime paste that has been slaked with enough water to make it moderately stiff. The lime paste should be kept in a loosely covered container for at least several days. Eight gallons of stiff lime paste can be made by slaking 25 lbs. of quicklime in 10 gallons of water, or by soaking 50 lbs. of hydrated lime in 6 gallons of water. After soaking, the paste should be strained through a fine screen to remove lumps or foreign matter.
On the other hand, in some cases there are legitimate reasons for one area to be bad even if the rest of the paint is solid. If poor body work or rust repair was done in the past then maybe just that section of paint will need to be removed.