The flag is referred to in the national anthem as the Flag of the Crescent and Star. It is flown on several important days of the year including Republic Day, Independence Day and Defence Day. It is often hoisted every morning at schools, offices and government buildings to the sound of the national anthem and lowered again before sunset. A notable flag raising and lowering ceremony is carried out each day with great pomp and enthusiasm at the Wagah Border attended by hundreds of spectators. The leadership of the Muslim League adopted the flag of the Dominion of Pakistan on 11 August 1947. The government of Pakistan has pronounced rules about the flying of the flag. It is to be displayed at full mast on 23 March of each year, marking the adoption of the Lahore Resolution in the 1940s[vague] and the Declaration of the Republic of Pakistan in 1956, and on 14 August in celebration of Independence Day, when Pakistan was carved out from British India as a home for Indian Muslims. The flag of Pakistan is also mentioned in Pakistan’s own national anthem in the third verse reading “پرچمِ ستاره و ہلال رہبرِ ترقّی و کمال” which translates to “Flag with the Star and Crescent, the leader of progress and ascent”.
If rubber-base paint has been used, the caustic soda treatment may not be effective and it may be necessary to use an organic solvent type of paint remover. Caution: - When using caustic soda or lye, avoid splashing eyes, skin, and clothing. You can use vinyl on almost any exterior except previously painted wood. It works fine on wood shingles and shakes, asbestos shingles, brick, stucco, concrete and masonry blocks. One manufacturer says you can even put it on wood clapboard if the clapboard is new and unprimed. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it.
Another popular color wheel called the Munsell color wheel, is slightly more involved. Instead of 6 basic colors, the Munsell wheel consists of ten colors: red, yellow-red, yellow, yellow-green, green, blue-green, blue, blue-violet, red-violet and violet. TEMPERATURE OF COLOR. Colors have temperature, referred to as warm or cool. In painting, reds, yellows and oranges are referred to as warm colors and blues, violets and greens are referred to as cool colors. One of the biggest lessons you will ever learn about color temperature though, is that the appearance of color can change drastically depending on its surroundings. For instance, a certain yellow would appear much hotter if it were surrounded by a violet then say an orange. Another important lesson in color temperature: Warm colors will advance in a painting and cool colors recede. At a minimum you want to remove all the chrome from the car. Take off both front and rear bumpers. If your Mustang has bumperettes that are body color be sure to bring them along so they can get sprayed at the same time as the rest of the car. Remove all rocker, hood and trunk molding. Same for wheel well molding and all emblems. This would be a good time to order some new emblems and attachment hardware. Also spend some time cleaning up all the chrome with #0000 steel wool. Nothing looks worse on a fresh paint job then faded emblems and corroded, cloudy chrome. Main thing to consider when considering painting exterior of your home is; How long do I plan living in this house. If your answer is any longer than 1 year, you may reconsider from painting trim only to painting exterior completely. From a quick glance, fresh trim paint will work from an aesthetic point of view, but not even close from complete protection and value points. Therefore, being fugal painting, does not always mean painting just enough to get by, sometimes costing much more in the long run.