Limewash - Made from slaked lime and water, this paint is good for porous surfaces such as brickwork, render and plaster and gives a chalky finish. It is available from specialist companies.
Cold water paints of the casein type may be applied either directly to a plastered surface, or the surface may be first given a coat of primer-sealer to equalize uneven suction effects. The same is true of resin-emulsion paints, with the recommendations of the manufacturer of the product being given preference in case of doubt. Since resin-emulsion paints usually contain some oil in the binder, they should ordinarily be applied only to plaster which has dried thoroughly.
The salt and alum should be dis-solved in 4 gallons of hot water, after which the molasses may be added to the mixture. The resulting clear solution is then added to the lime paste, stirred vigorously, and thinned with water to the desired consistency. This whitewash has a yellow tinge when first applied, but the color disappears in a few days leaving a white film.
What emotions does it produce?
Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present.
You can tell when the bucket of paint is getting low when the airless starts pumping really loud and doesn't stop. Simply tip the nearly empty bucket of paint, at an angle so that the mesh filter is covered and wait for the airless to catch up and stop pumping. Sometimes it's just easier to just to replace the bucket of paint with the new one and when that starts going down, pour the excess from the old bucket into the new one.
Color - The paint makers are out to sell the lady of the house and color is their come-on. They are tempting her with a kaleidoscope's variety; one firm offers more than 6,000 different shades.