Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel. When spraying your house, it is a good rule of thumb to spray in the direction of the grain of the material. So if you have siding that runs horizontal, you want to spray in a horizontal style. Also, when you go to spray, the gun should be approximately 12" from the material that you are spraying. Do not pull the handle to spray with your hand still. This will spray a lot of paint in one spot causing it to drip. So have your hand moving when you go to depress the handle. This will give you an even look to your paint. Blue is the color of calmness and peace. It draws in and intoxicates. The strength of this color is as a rule underestimated. It creates precondition for deep reflection about life, calls to find the meaning and truth, it calls for not sensual but rather spiritual impressions.
WALL PAINTING TIPS. · Paint around the trim first, including edging around the ceiling. · When painting with a gloss finish, make the final brush strokes away from the light source of the room. The tiny ridges that a brush leaves won't be as pronounced. Use the same "wet to dry" method of painting. OK, let's get started. Step one...supplies. You need a flat brush, a fan, a small detail brush and a couple of Filberts. A filbert is a rounded edge brush that lets you maneuver the paint easily without going outside the edges. Ultimately buy brushes that you like though, and make them work. Fans allow you to blend, for example. I use fans a lot and it's how I graduate color throughout my images. Everything I paint is by hand....no airbrushing or assistants. I want it to be an expression of me and nobody else. You also need an oil painting medium to mix with the oil paint to make it more fluid, and to speed or slow the drying process. Whichever you prefer. Go to the art store and don't be afraid to ask for help....they'll love helping you! A medium is merely an additive liquid which increases gloss, makes it flow easily, preserves the finish over time, keeps it from yellowing. I personally love Galkyd and Galkyd Lite. If that isn't available, buy a medium that looks like liquid amber and is kind of thick. Don't buy watery looking mediums....too hard to work with. Valspar Paint, for instance, also produces paint branded as Laura Ashley, Eddie Bauer, Waverly, and more. These separate lines, or collections, have their own color wheel displays and are usually available wherever the primary brand, Valspar in this case, are sold. Other examples are Disney Paints, currently produced by Behr, and Ralph Lauren and Martha Stewart, formerly produced by Sherwin Williams. Plaster. New dry plaster in good condition, which is to be finished with a paint other than water paint, should be given a coat of primer-sealer and allowed to dry thoroughly before being inspected for uniformity of appearance. Variations in gloss and color differences in the case of tinted primers indicate whether or not the whole surface has been completely sealed. If not, a second coat of primer-sealer should be applied. If only a few "suction spots" are apparent, a second coat over these areas may be sufficient.