Wood Walls and Trim. New interior walls and wood trim should be smoothed with sand-paper and dusted before painting or varnishing. To preserve the grain of the wood, the surface may be rubbed with linseed oil, varnished or shellacked, and waxed. If an opaque finish is desired, semi-gloss paint thinned with 1 pint of turpen-tine per gallon of paint or the primer-sealer previously described for walls may be used as a priming coat on wood. One or two coats of semi-gloss paint should then be applied over the thoroughly dry prime coat, or if a full-gloss finish is desired, the last coat should be a high-gloss enamel.
Paying for a Brand Name Paint Color? If you are worried about ending up with an ugly paint color, you may be somewhat safer utilizing one of these designer collections. However, the color range offered by any one of these alternative brands is very limited and typically the whole line of hues is all neutralized to about the same tone. This gives the smaller brand a nice consistent look, but it doesn't allow for much variety. Also, these signature paints are typically more expensive (often 50% more) despite the fact that you can get very similar colors from the primary "mother" brand for considerably less money.
If you decide to do your own body work discuss it with the paint shop first. They'll probably have recommendations on the type of primer you use. Some brands will be more compatible with their primers or color coats. The rule of thumb is to stay within the same brand of paint, both for prep and color. Even the cheapest paint shops typically use a brand name on their intermediate and higher paint jobs. Find out what it is and use the same brand as your primer coat. This will ensure you don't create adhesion problems for yourself down the road.
Choose from historical hues for period homes; sleek chalky finishes that stand up to the rigours of modern life; or new formulas designed to suit all surfaces. By understanding the product you can unleash all the design possibilities of paint that make it such a tempting medium.
Store your leftover paint in plastic Rubbermaid beverage jugs or other plastic seal-able containers. Paint left in the can always gets funny after time. Either the can isn't properly sealed of it gets exposed to extreme heat or cold. I like to store my paint inside where the temperature is controlled.
To balance color, you must grasp the interconnectedness of color schemes. All color interactions are defined in the color wheel, and it has been used to build color schemes for centuries.
Concrete Floors. Two general types of paints for concrete floors are varnish and rubber-base paint. Each has its limitations and the finish cannot be patched without the patched area showing through. Floor and deck enamel of the varnish type gives good service on concrete floors above grade where there is no moisture present.