Composition Wallboard. Composition wallboard usually presents no particular painting difficulties if the ordinary precautions are observed, such as making certain that the surface is dry and free from grease and oil. The painting procedure for wallboard is the same as for plaster; it requires a priming and sealing coat followed by whatever finishes coats are desired, or may be given one-coat flat or resin-emulsion type paint.
Special Surfaces. WHITEWASH. Whitewashes and lime paints must be thin when applied. In fact, best results will be obtained if the application is so thin that the surface to which it is applied may easily be seen through the film while it is wet. The coating will dry opaque, but two thin Coats will give better results than one thick coat.
EXTERIOR PAINTING. In buying paints that you are going to use for your exterior house, you have to pick a brand that has essential characteristics: hiding power, color retention, chalk-resistance, and blister resistance.
Will the color fade? Now this is a very broad question with various answers. Hair color fading is due to many factors. First of which is, the ability of the hair to hold hair color. We call this porosity. If the hair is overly porous it will have a problem holding hair color. There are ways a stylist can usually alleviate this problem. Once in a while the hair is so damaged it absolutely impossible for the hair to hold color. Your stylist should always have the skills to evaluate these situations, and recommend certain conditioning treatments to bring the hair back to a normal porosity.
Knock down texture is basically a orange peel that is sprayed on and allowed to "set-up" for a minute or two then gently "knocked down" by running a 6" drywall knife over it, "knocking down" the surface of the texture. Although knock down is a flattened version of orange peel, I suggest you do not use a spray can of orange peel, the knock down comes in its own spray can and the results are much better, again experiment before spraying it on the wall. However, If ever you apply any of the textures to the wall and are not satisfied with the results, wash the texture off immediately before it dries, then allow the wall to dry and try it again. Once you have the texture applied to your liking and you have allowed it to dry, you may want to paint the patches a couple of time before painting the entire wall, especially for walls where the paint to be applied will have some sheen. Multiple coats on these areas will make them blend in, unnoticeable, with the rest of the wall. You will know if the patches need more coats of paint, because the patch/texture will have absorbed the paint causing the spot to look duller than the rest of the existing wall.
Now that you have primed the airless, make sure that there isn't a tip in the gun of the airless and bring it over to the empty bucket. Since there is typically cleaning solution in the hose leading to the gun it is a good idea to spray that out until you see thick paint coming out. Once you have thick paint coming out you may put your tip back in. Remember that the tip will have an arrow on one side of the handle that shows which direction it must be in, in order to spray.
If you have a timber floor that's not particularly attractive or is made from a patchwork of old and new wood, paint makes the perfect disguise. There are plenty of choices - all the colours from Farrow & Ball are available as floor paint and Nordic Style offers an elegant selection, too.