Paying for a Brand Name Paint Color? If you are worried about ending up with an ugly paint color, you may be somewhat safer utilizing one of these designer collections. However, the color range offered by any one of these alternative brands is very limited and typically the whole line of hues is all neutralized to about the same tone. This gives the smaller brand a nice consistent look, but it doesn't allow for much variety. Also, these signature paints are typically more expensive (often 50% more) despite the fact that you can get very similar colors from the primary "mother" brand for considerably less money. The second part of preparation is surface prep, it addresses covering the surfaces you do not want to get any paint on. A little plastic sheeting will go along way to keeping paint off of floors, window coverings, handrails, cabinets, counter tops, etc... And, if you are not confident with your ability to paint a straight line next to door casing, baseboards, cabinets or hardware protect these surfaces using masking tape. There are two basic types of masking tape white/yellow and blue. The white tape sticks to surfaces better but, can pull off finishes on cabinets or stained woodwork. Blue tape usually will not pull off finishes but, does not stick as well, this will probably be the tape to use for most applications. Always wipe down or dust the surface you will be masking to assure the best tape adhesion possible. If you use blue tape you may need to re-rub down the tape before painting next to it, only mask off areas with blue tape that you will be painting for a given day. With either tapes, do not assume the are a force field that paint will not penetrate, use them as a reference and dry brush the paint next to the edge of the tape and avoid soaking the edge of the tape with a lot of paint, this will cause the paint to "bleed" through giving you an undesired look. If you will need to apply multiple coats of paint, on the first coat, paint as close to the tape as you can, not really getting paint on the tape. With the second coat or a one coat application, you can use the tape more of like a paint barrier and get a little more paint on the tape if you immediately remove each section of tape after painting the section, this will keep the paint from sitting on the tape and "bleeding" behind it. Also, if you get a lot of paint on the tape it is not good to let the paint dry on the tape because some paints (especially the glossier paints) will peel if allowed to dried, with the tape when it is pulled off. White tape should not be left on for longer than a couple of days and I suggest not leaving it on more than a day in areas that receive long periods of direct sunlight. Blue tape can be left on for days, if it will stay on, there again it does not stick as well and may need rubbed down again immediately before painting up next to it. Remember, you will need to clean the airless in that same fashion before you return the airless back to the rental company.
Intensity refers to a colors brightness or saturation. Intensity refers to how pure a color is. For instance, if you were to use cadmium red straight from the tube, it would have a high intensity. If you were to mix it with another color however, its intensity would be diminished. Practically every manufacturer has a "color system," a fat book of color chips with instructions for duplicating each chip. This is accomplished by intermixing cans of colored paint, by adding a concentrated color to a can of white or colored paint, or by adding concentrated color or colors to a can of neutral "base" paint. And for those who don't want any guesswork there's the Color Carousel that mixes the paints right in the store. Whatever the method, the result is a range of colors such as no amateur painter has seen. If you have a timber floor that's not particularly attractive or is made from a patchwork of old and new wood, paint makes the perfect disguise. There are plenty of choices - all the colours from Farrow & Ball are available as floor paint and Nordic Style offers an elegant selection, too. So what exactly makes a rose appear "red" or grass appear "green". In the green grass, you are only seeing green because the grass has pigments in it that absorb all colors of the solar spectrum except green. So green is the color that is reflected back to your eyes. The same holds true for the red rose, only the rose absorbs all colors of the spectrum besides red.